Skip Top nav bar link group topnav end piece go to business section go to education section go to history section go to gallery section go to news section go to organizations section go to research section go to search engine go to site index topnav end piece
NASA Meatball NASA Dryden F-15B banner
The Aerostructures Test Wing (ATW), which consisted of an 18-inch carbon fiber test wing with surface-mounted piezoelectric strain actuators, following intentional failure on its final flight The Aerostructures Test Wing (ATW), which consisted of an 18-inch carbon fiber test wing with surface-mounted piezoelectric strain actuators, following intentional failure on its final flight

Photo Number: EC01-0124-1
Photo Date: April 24, 2001

Formats: 524x480 JPEG Image (76 KBytes)
1117x1023 JPEG Image (387 KBytes)
3000x2750 JPEG Image (3,864 KBytes)

Description:

A flight experiment called the Aerostructures Test Wing (ATW) conducted at NASA's Dryden Flight Research Center, Edwards, Calif., successfully demonstrated a new software data analysis tool, the flutterometer, which is designed to increase the efficiency of flight flutter testing.

The photo shows the experiment, which consisted of an 18-inch carbon fiber test wing with surface-mounted piezoelectric strain actuators, following intentional failure on its final flight. The test wing was mounted on a special ventral flight test fixture and flown on Dryden's F-15B Research Testbed aircraft.

Five flights consisted of increasing speeds and altitudes leading to the final test point of Mach .85 at an altitude of 10,000 feet. At each Mach and altitude, stability estimations of the wing were made using accelerometer measurements in response to the piezoelectric actuator excitation. The test wing was intentionally flown to the point of structural failure, resulting in about a third of the 18-inch wing breaking off. This allowed engineers to record the effectiveness of the flutterometer over the entire regime of flutter testing, up to and including structural failure.

Research objectives of the ATW experiment included validation of the new flutterometer, validation of aerodynamic load predictions on the test wing, and analytical strain gage calibration techniques.


NASA Photo by: Tony Landis

Keywords: Aerostructures Test Wing; flutter; flutterometer; ATW; F-15B; FTF; Flight Test Fixture


Last Modified: February 6, 2002
Responsible NASA Official: Marty Curry
Curator: PAO Webmasters

NASA Website Privacy Statement