|Dryden Home > Collections > Movies Home > Mini-Sniffer > EM-0061-03|
Mini-Sniffer Test Flight Over Rogers Dry Lake
160x120 QuickTime Movie (2.9 MB)
320x240 QuickTime Movie (5.8 MB)
480x360 QuickTime Movie (8.7 MB)
640x480 QuickTime Movie (14.6 MB)
|Still photos of this aircraft are available in several resolutions at
This 81 second movie shows flight and landing of the Mini-Sniffer remotely controlled, propeller-driven vehicle.
Mini-Sniffer was the first effort to build a high-altitude remotely piloted research vehicle for both Earth atmospheric studies and for possible use as a Mars aircraft. It was flown under radio control by an operator riding in the back of a pickup truck. Another vehicle carried the data recording equipment.
The Mini-Sniffer was a remotely controlled, propeller-driven vehicle developed at NASA Dryden Research Center to sample the upper atmosphere for pollution. The Mini-Sniffer represents one of the earliest attempts by NASA to monitor the earth's atmosphere at high altitudes and was also considered for planetary atmospheric sampling flights over Mars. There were three Mini-Sniffers built. The original Mini-Sniffer was propelled by a small air-breathing engine, while a later version employed a non-airbreathing hydrazine engine for higher altitude capabilities. A large propeller was also employed because of its effectiveness in the thin upper atmosphere.
The number I aircraft had swept wings with a span of 18 feet, wing rudders, and forward canards on the nose. Twelve flights were made with the gas powered number I craft at low altitudes around 2500 feet above ground level. The number I craft was modified into version II by removing the canards and wing rudders, then adding wing tips and tail booms. Twenty-one flights were made to 20,000 feet with this modified 22 foot wing configuration. The number III vehicle had a longer fuselage, was lighter in weight, was similar in shape to the number II, and was powered by adding the non-airbreathing hydrazine engine. The number III Mini-Snuffer was designed to fly a 25 pound payload to 70,000 feet for one hour or to climb to 90,000 feet and glide back. The Mini-Snuffer III made one flight to 20,000 feet and was not flown again due to a hydrazine leak problem.
|Keywords||Mini-Sniffer, remotely controlled, propeller-driven, vehicle|