|Dryden Home > Collections > Movies Home > AD-1|
The Ames-Dryden-1 (AD-1) aircraft was designed to investigate the concept of an oblique (pivoting) wing. The wing could be rotated on its center pivot, so that it could be set at its most efficient angle for the speed at which the aircraft was flying.
It was designed as a low-cost/low-speed research aircraft to test a pivot wing design. The AD-1 took off with its wing positioned at a right angle with the fuselage. Once in the air, the wing would rotate on its pivot point on the fuselage until it formed a 60 degree angle. The goal was to design a high-speed transport with low drag. The AD-1 made a total of 79 flights, but adverse handling at sharp sweep angles made the approach less attractive.
NASA Ames Research Center Aeronautical Engineer Robert T. Jones conceived the idea of an oblique wing. His wind tunnel studies at Ames (Moffett Field, CA) indicated that an oblique wing design on a supersonic transport might achieve twice the fuel economy of an aircraft with conventional wings. The oblique wing on the AD-1 pivoted about the fuselage, remaining perpendicular to it during slow flight and rotating to angles of up to 60 degrees as aircraft speed increased. Analytical and wind tunnel studies that Jones conducted at Ames indicated that a transport-sized oblique-wing aircraft flying at speeds of up to Mach 1.4 (1.4 times the speed of sound) would have substantially better aerodynamic performance than aircraft with conventional wings.
The AD-1 structure allowed the project to complete all of its technical objectives. The type of low-speed, low-cost vehicle, as expected, exhibited aeroelastic and pitch-roll-coupling effects that contributed to poor handling at sweep angles above 45 degrees. The fiberglass structure limited the wing stiffness that would have improved the handling qualities. Thus, after completion of the AD-1 project, there was still a need for a transonic oblique-wing research aircraft to assess the effects of compressibility, evaluate a more representative structure, and analyze flight performance at transonic speeds (those on either side of the speed of sound).
The aircraft was delivered to the Dryden Flight Research Center, Edwards, CA, in March 1979 and its first flight was on
The aircraft was 38.8 feet long and 6.75 feet high with a wing span of 32.3 feet, unswept. It was constructed of plastic